This version is configurable to support Analog VHF/VHF MURS/UHF bands
The Loudmouth PA system is a radio receiver that allows you to use your portable, base station or mobile 2-way radio to deliver voice messages directly to a PA speaker. The receiver and PA speaker is the ideal solution where hard-wired PA installation is simply impossible, too expensive, or temporary. Once installed, operating the Wireless Public Address radio receiver requires no human contact.
Includes:
LM-600 Loudmouth Radio receiver
05500040 horn speaker
RPS-1B power cube
AFB-1545 dual band antenna
RK-RQX-Q-MB mounting bracket
25107400 T-25 torx security bit
The LoudMouth radio receiver is small and lightweight (7"H x 5"W x 3"D, 2lbs). It is housed in a rugged, sealed, weather-resistant housing and includes a wall mounting bracket. The radio receiver should be mounted indoors away from the elements.
The indoor /outdoor 5 Watts horn speaker provides 85 dB of audio output @ 50 feet, so even in noisy environments you can get your message out loud and clear. The loud PA horn speaker includes a mounting bracket.
5 Pre-set Volume Output Levels to select from
Each LoudMouth radio receiver and PA speaker combination can be paged individually. Multiple units can be placed throughout a facility, programmed identically, and activated simultaneously as a group.
9 Auto Shut-Off Timer selections (5 seconds to 4 minutes). After receiver is successfully paged, a pre-set timer will begin count down. A valid radio signal must be received within the selected time interval or the receiver will re-set.
Features:
1 Channel
5w audio amplifier
Can be used with radios programmed for Quiet Call (CTCSS), Digital Quiet Call (DCS), 2-Tone Paging, DTMF, or Selcall paging formats
Field programmable paging codes
Dual Band Receiver
VHF/UHF Configurable Supports:VHF (150-165MHz) and UHF (450-470 MHz), MURS
