The Loudmouth PA system is a radio receiver that allows you to use your portable, base station or mobile 2-way radio to deliver voice messages directly to a PA speaker. The receiver and PA speaker is the ideal solution where hard-wired PA installation is simply impossible, too expensive, or temporary. Once installed, operating the Wireless Public Address radio receiver requires no human contact.
Switch Input with Pre-Recorded Message – Allows Optional NO or NC switch to activate a recorded voice message played solely on single attached LM receiver/speaker.
LM Receiver Supports Up To 2 PA Speakers – requires optional RYCONN Cable and additional PA Speaker
Up to 4 Pre-Recorded Stored Messages – Selectively trigger each stored voice message using a UID from the 2-way radio
Signaling Decode: Color Codes, SUID, Destination Type and Destination ID
The LoudMouth radio receiver is small and lightweight (7"H x 5"W x 3"D, 2lbs). It is housed in a rugged, sealed, weather-resistant housing and includes a wall mounting bracket. The radio receiver should be mounted indoors away from the elements.
The indoor /outdoor 5 Watts horn speaker provides 85 dB of audio output @ 50 feet, so even in noisy environments you can get your message out loud and clear. The loud PA horn speaker includes a mounting bracket.
5 Pre-set Volume Output Levels to select from
Each LoudMouth radio receiver and PA speaker combination can be paged individually. Multiple units can be placed throughout a facility, programmed identically, and activated simultaneously as a group.
9 Auto Shut-Off Timer selections (5 seconds to 4 minutes). After receiver is successfully paged, a pre-set timer will begin count down. A valid radio signal must be received within the selected time interval or the receiver will re-set.
Includes:
LM-700DMR
Dual Band whip antenna
RPS-1B 110VAC Power Supply
05500040 PA Horn Speaker Indoor/Outdoor rated with 25 ft. cord
